Related Articles

A fridge by having an ice that is automated and an integral water dispenser does nothing at all if you don’t have water line in order to connect to it. Many domiciles have fridge water supply line set up during initial construction, but this particular feature wasn’t contained in the building that is original of some domiciles. You are able to re re solve this by having an ice manufacturer installation kit which allows one to make use of the plumbing underneath the sink. The kit gives you the desired components to connect a water line up to your fridge.

Find your water supply lines beneath your sink. You’ve probably three water supply lines under the sink; two lines link right to the tap although the third line links into the dishwasher. The valve attached to the right region of the tap could be the water supply line that is cold. Turn the water that is cold the supply line clockwise to shut it.

Connect a drill that is 5/16-inch to your drill. Drill holes into the base case walls to route the water line from under the sink to your back regarding the fridge. Drill since near to your straight back wall for the case as you are able to, so that you usually do not lose storage area in the case.

Thread the water line, contained in the ice manufacturer installation kit, through the area behind the fridge to underneath the sink. Leave the extra water line behind the fridge.

Start the cold water faucet to strain any water kept when you look at the supply line. Utilize pliers to untwist the faucet supply line through the water supply valve that is cold.

Wrap threads regarding the water that is cold with 2 or 3 wraps of thread-seal tape. Twist the male end of a quick-tee adapter onto the valve. Wrap the female thread on the alternative end for the adapter with thread-seal tape. Twist the faucet supply line on the female end associated with adapter.

Slip the compression nut that was included with the kit within the newly set up supply line. Verify the threads are dealing with the final end regarding the line. Thread the ferrule from the kit on the brand new line.

Wrap the rest of the male threads regarding the quick-tee adapter with thread-seal tape. Insert the brand new water line to the opening regarding the tee. Slip the compression nut within the male threads and tighten up it regarding the adapter.

Fasten all three nuts regarding the quick-tee adapter with pliers or a wrench that is adjustable. Try not to twist the nuts too tight since this might harm the supply valve, the supply line while the adapter.

Put the finish of this water line you would like to hook up to the ice box right into a bucket that is 5-gallon. Turn the water that is cold valve on under the sink. Allow a few gallons of water explain to you the brand new line to take away the atmosphere. Turn from the supply line.

Slip the rest of the compression nut and ferrule on the ice box end associated with brand new water line. Connect the relative line towards the water line connector from the back of this refrigerator.

Turn the supply line on once more. Watch out for leakages at all the connections. Fasten the connections slightly if a leak is seen by you. If tightening the bond will not stop the drip, turn down water, get rid of the connector and include extra thread-seal tape before reconnecting water line.

Plug your fridge to the wall. Coil the water that is excess behind the ice box. Drive the refrigerator from the wall surface.